YY-115 | C2TE High-Performance Tile Adhesive
Product Overview
C2TE Tile Adhesive is a a premium, bagged polymer cement powder with acrylic latex inside to be mixed with only water to install low absorption ceramic tile, porcelain tile and natural stone using the thin-set method of installation.
For dependable results, specify C2TE High-Performance Tile Adhesive as part of a complete system, verify substrate compatibility, and follow the approved technical data sheet and site trial.
In specification and procurement searches, porcelain tile adhesive is the primary product term for this page. Buyers comparing a porcelain tile adhesive manufacturer can evaluate technical compatibility, packaging, and project support with YUNYAN. For applications requiring tile adhesive for porcelain, complete a site trial and follow the approved installation method.
Key Features & Benefits
· Interior and exterior use.
· Polymer cement based, add water only.
· Green product, low VOC.
Recommended Applications
· It is suitable for interior and exterior installation of granite, marble and all kinds of porcelain tiles’ bonding.
· Concrete masonry.
· Cement mortar beds.
· Cement plaster.
· Suitable waterproof membranes.
· Brick masonry.
Why Choose YUNYAN
Choose this product when the project brief calls for porcelain tile adhesive with clear technical documentation and consistent supply. YUNYAN supports importers, contractors, and distributors that need a responsive porcelain tile adhesive manufacturer. Where the specification requires tile adhesive for porcelain, the final system should be confirmed against substrate conditions and service exposure.
Technical Information
|
Open Time |
EN 1346 | > 25 minutes |
|
Pot Life |
> 60 minutes |
|
Ready to Grout |
24 hours |
|
Time to Light Traffic |
24 hours |
|
High initial tensile adhesion strength |
EN 1348 | ≥1.0 N/mm² |
|
High tensile adhesion strength after water immersion |
EN 1348 | ≥1.0 N/mm² |
|
High tensile adhesion strength after heat ageing |
EN 1348 | ≥1.0 N/mm² |
|
High tensile adhesion strength after freeze - thaw cycles |
EN 1348 | ≥1.0 N/mm² |
|
Early tensile adhesion strength 4 hours |
EN 1348 | ≥1.0 N/mm² |
|
Slip |
EN 1308 | ≤0.5 mm |
Technical values are typical source-document values and should be checked against the latest approved TDS before publication, specification, or site use.
Application Guide
1. All surfaces should be between 4°C and 32°C and structurally sound, clean and free of all laitance, dirt, oil, grease, loose peeling paint, concrete sealers or curing compounds.
2. Dry, dusty concrete slabs or masonry should be dampened and excess water swept off.
3. Installation.
4. may be made on a damp surface.
5. New concrete slabs shall be cured and 28 days old before application.
Packaging, Storage & Safety
|
Storage / Shelf Life |
SHELF LIFE: Sealed bags are guaranteed to be 12 months if stored at between 5℃ to 40℃. Non-warranty: Because the storage, handling and application of the material is beyond YUNYAN COMPANY control, we can accept no liability for the results obtained. YUNYAN COMPANY sole limited warranty is the product meets the manufacturing specifications in effect at time of manufacturing. There is no warranty of merchantability or fitness for use, nor any other express or implied warranty. |