YY-4030 | Water-Borne Wood Paint

YUNYAN YY-4030 is a water-borne decorative and protective coating for properly prepared wood surfaces. The product is intended to provide a uniform finish with practical recoating, lower odor than conventional solvent-borne coatings, and project color options subject to confirmation.

For dependable results, specify Water-Borne Wood Paint as part of a complete system, verify substrate compatibility, and follow the approved technical data sheet and site trial.

In specification and procurement searches, water based wood paint is the primary product term for this page. Buyers comparing a water based wood paint manufacturer can evaluate technical compatibility, packaging, and project support with YUNYAN. For applications requiring low odor paint for wood furniture, complete a site trial and follow the approved installation method.

Key Features & Benefits

· Water-borne coating format for easier cleanup and lower application odor.

· Decorative color and finish options for wood surfaces.

· Suitable for brush, roller, or spray application subject to the final TDS.

· Can be maintained or recoated after suitable surface preparation.

· Use with a compatible wood primer or sealer where required.

Recommended Applications

· Interior wooden doors and trim.

· Furniture and cabinetry.

· Decorative timber panels.

· Selected protected exterior wood with an approved system.

· Residential and commercial refurbishment.

Why Choose YUNYAN

Choose this product when the project brief calls for water based wood paint with clear technical documentation and consistent supply. YUNYAN supports importers, contractors, and distributors that need a responsive water based wood paint manufacturer. Where the specification requires low odor paint for wood furniture, the final system should be confirmed against substrate conditions and service exposure.

Application Guide

1. Prepare the substrate by removing rust, dust, grease, loose coatings, salts, and other contamination.

2. Stir or mix the product thoroughly; thin only with the approved material and within the TDS limit.

3. Apply the specified number of even coats by brush, roller, or spray, respecting recoat windows and target film build.

4. Protect the coating from rain, condensation, dust, and service loads until fully cured.