YY-4020 | Water-Based Acrylic Enamel Finish Paint

Rolls water-based acrylic anti-corrosive topcoat is a one-component high-grade. water-based acrylic topcoat with good color retention. The paint film is resistant to. abrasion, collision, salt water, mineral oil and various chemicals.

For dependable results, specify Water-Based Acrylic Enamel Finish Paint as part of a complete system, verify substrate compatibility, and follow the approved technical data sheet and site trial.

In specification and procurement searches, water based enamel paint is the primary product term for this page. Buyers comparing a water based enamel paint manufacturer can evaluate technical compatibility, packaging, and project support with YUNYAN. For applications requiring acrylic enamel paint for metal, complete a site trial and follow the approved installation method.

Key Features & Benefits

· Provides a uniform protective and decorative film on compatible, correctly prepared substrates.

· Designed for practical brush, roller, or spray application according to product type.

· Supports project color selection and a consistent finish.

· Suitable for maintenance, renovation, and new construction coating work.

· Can be used with compatible primers and intermediate coats as part of a complete coating system.

Recommended Applications

· Used as a top coat on steel structures and concrete surfaces in moderate to severely.

· corrosive environments.

· It can also be used as a non-yellowing wood surface and the.

· surface of various electrical appliances, meters, instruments, mechanical equipment.

· and other metal equipment for decorative protection.

· Paint base: water-based acrylic resin.

Why Choose YUNYAN

Choose this product when the project brief calls for water based enamel paint with clear technical documentation and consistent supply. YUNYAN supports importers, contractors, and distributors that need a responsive water based enamel paint manufacturer. Where the specification requires acrylic enamel paint for metal, the final system should be confirmed against substrate conditions and service exposure.

Technical Information

Technical values are typical source-document values and should be checked against the latest approved TDS before publication, specification, or site use.

Application Guide

1. Prepare the substrate by removing rust, dust, grease, loose coatings, salts, and other contamination.

2. Stir or mix the product thoroughly; thin only with the approved material and within the TDS limit.

3. Apply the specified number of even coats by brush, roller, or spray, respecting recoat windows and target film build.

4. Protect the coating from rain, condensation, dust, and service loads until fully cured.

Packaging, Storage & Safety