YUNYAN NEW BUILDING MATERIALS LIMITED is a professional supplier and wholesaler for rapid set adhesive,YUNYANMIX is well branded, one of TOP 10 brands in China, more informations please go through: http://www.yunyanchina.com/products
PRODUCT DESCRIPTION:
116F Rapid Set Adhesive is a a premium, flexible, high performance, rapid setting, bagged polymer cement powder manufactured by YUNYAN to be mixed with only water to install low absorption ceramic tile, porcelain tile and natural stone using the thin-set method of installation.
PRODUCT FEATURES:
Ø Interior and exterior use
Ø Rapid setting, flexible and non sag
Ø Polymer cement based, add water only
Ø Green product, low VOC
Ø No asbestos
WHERE TO USE:
It is suitable for interior and exterior installation of granite, marble and all kinds of tiles’ bonding.
Suitable Substrates:
Ø Concrete masonry
Ø Cement mortar beds
Ø Cement plaster
Ø Ceramic tile and stones
Ø Suitable waterproof membranes
Ø Brick masonry
Ø Cement terrazzo
Ø Gypsum wall board
PACKAGE:
Ø 20kg per bag, 50/60 bags in a pallet
Ø 25kg per bag, 40/60 bags in a pallet
Ø Colors: gray/white
TECHNICAL DATA:
|
Test Item |
Test Method |
Result |
|
Open Time |
EN 1346 |
> 15 minutes |
|
Pot Life |
-- |
> 40 minutes |
|
Ready to Grout |
-- |
3 - 4 hours |
|
Time to Light Traffic |
-- |
4 hours |
|
Transverse Deformation |
EN 12002 |
≥ 2.5 mm and < 5 mm |
|
High initial tensile adhesion strength
|
EN 1348 |
≥1.0 N/mm² |
|
High tensile adhesion strength after water immersion |
EN 1348 |
≥1.0 N/mm² |
|
High tensile adhesion strength after heat ageing |
EN 1348 |
≥1.0 N/mm² |
|
High tensile adhesion strength after freeze - thaw cycles |
EN 1348 |
≥1.0 N/mm² |
|
Early tensile adhesion strength 4 hours
|
EN 1348 |
≥1.0 N/mm² |
|
Slip |
EN 1308 |
≤0.5 mm |
UNIT COVERAGE:
1.2kg/mm/m2, one bag 20kg can cover 5-6 square meters at 3mm thickness adhesive.
SHELF LIFE:
Sealed bags are guaranteed to be 12 months if stored at between 5℃ to 40℃.
HOW TO APPLY:
Surface Preparation:
All surfaces should be between 4°C and 32°C and structurally sound, clean and free
of all laitance, dirt, oil, grease, loose peeling paint, concrete sealers or curing compounds.
Dry, dusty concrete slabs or masonry should be dampened and excess water swept off. Installation
may be made on a damp surface. New concrete slabs shall be cured and 28 days old before application. Latex Portland cement mortars do not require a minimum cure time for cement slabs. All substrates must be plumb and true to 5 mm in 3 m when measured from the high point. Expansion joints shall be provided through the tile work, over all construction or expansion joints in the substrate. Do not cover expansion joints with adhesive.
